Notes On SPRAYABLE Joint Sealant - Ah97.10-P-0002-01A

Model 450.3/4, 451.3/4, 452.3/4, 453, 454.0 

Model all (4xWD, BUS, CAR, Light transporter) 

Application areas: 

With this material, when applied over large surfaces on areas such as the wheelhouses, longitudinal members (rocker panels) and vehicle floor elements, the characteristics are visually equivalent to the standard or plant seals in terms of the processing.

When applying the material from the standard cartridge (300 ml), a special compressed air gun is required which allows different types of application for structured joints, surface coatings, stone-impact protection and sound deadening in combination with the associated plastic injection nozzles.

Processing procedure: 

• Wet-in-wet coating possible between 30 minutes and 8 hours after application without paint additives. Oven drying is necessary between 8 hours and 72 hours. Longer standing times should be avoided to exclude paint adhesion losses.
• Adhesion surfaces must be clean, dry and free of grease.
• Filler/filler primer should be sprayed on before application of sprayable seam sealant.
• Do not apply sprayable seam seal onto fresh (uncured) 1K-polyurethane material.

Specific material advantages of "sprayable joint sealing agent": 

• Does not contain any isocyanates, silicone, PVCs and no dangerous agent.
• The replaceable nozzle makes cleaning unnecessary.
• Visual repair of plant seals and underbody coating.
• Good stability.
• UV-resistant.
• Material offers a number of application possibilities.
• The sprayable seam sealant and surface coating can be applied one after another with corresponding gun setting.
• It is necessary, however, to wait for the end of the skin formation period of about 15 min. for the sprayed seam.
• Can be painted over well.