Remove/Install Rear Switching Module Sensors - AR80.61-P-0012ME

Model 167 

with code 871 (HANDS-FREE ACCESS) 

Fig 1: Rear Switching Module Sensors Components Location - With Code 871

Courtesy of MERCEDES-BENZ USA

Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).
2	Remove rear bumper and set down on suitable base.		AR88.20-P-2200ME
3	Release and disconnect electrical connectors (1) and remove lower rear switch module sensor (A87/2).
4	Release the circumferential retaining lugs (2) and remove upper rear switch module sensor (A87/1) with bracket (3).	Dismantling tool	Fig 2
5	Install in the reverse order

Fig 2: Identifying Dismantling Tool (000 589 95 63 00)

Courtesy of MERCEDES-BENZ USA