Remove/Install Side Supplemental Restraint System (SRS) Pressure Sensor - AR91.60-P-0760ME
Model 167
| Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical component parts to temperatures above 100°C or 212°F. Disconnect current supply when working on such component parts. | AS91.00-Z-0008-01A | |
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Information, assessment and legal requirements when working with, handling and storing pyrotechnical components | AH91.00-Z-0000-10A | ||
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Clamp off ground line of on-board electrical system battery (G1). | AR54.10-P-0003ME | |
| 2.1 | Remove front door trim. | If the left front door pressure sensor (B48/7) of the right front door pressure sensor (B48/8) is removed. | |
| AR72.10-P-6575ME | |||
| 2.2 | Remove rear door trim. | If the left rear door pressure sensor (B48/9) or right rear door pressure sensor (B48/10) is removed. | |
| AR72.12-P-1011ME | |||
| 3 | Release electrical connector (1) and disconnect. | ||
| 4 | Twist the respective pressure sensor (B48/7, B48/8, B48/9, B48/10) in direction of arrow and remove. | ||
| 5 | Install in the reverse order. | ||
| Check | |||
| 6 | Check Supplemental Restraint System (SRS) using vehicle diagnosis system. | If the pressure sensor (B48/7, B48/8, B48/9, B48/10) was replaced. | |
| AD00.00-P-2000-06ME |