Remove/Install Tilting/Sliding Roof Motor - AR77.20-P-3010ME

Model 167.1 

With Code 414 (Electric sunroof, glass version) 

MODIFICATION NOTES

12.07.2022

Lower headliner until sliding sunroof control module (A98/1) is accessible.

Operation step 3.

Fig 1: Tilting/Sliding Roof Motor Components Location - Model 167.1 With Code 414

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
Notice	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Perform commissioning of sliding sunroof control module (A98/1).	When replacing sliding sunroof control module (A98/1).
			AD00.00-P-2000-06ME
2	Move sliding sunroof to tilt position.
3	Lower headliner until sliding sunroof control module (A98/1) is accessible.		AR68.30-P-4300ME
4	Remove screws (1).
5	Remove sliding sunroof control module (A98/1).
6	Release and disconnect electrical connector (2) and remove sliding roof control module (A98/1).	The sliding sunroof motor (A98/1m1) is part of the sliding sunroof control module (A98/1).
7	Install in the reverse order.