Remove/Install Seal For Sliding Roof Panel - AR77.21-P-0560MEC

Model 167.3 

With Code 413 (Panoramic sliding sunroof/glass roof) 

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove sliding roof panel.	When removing seal (1, 5, 7).	AR77.21-P-0503MEC
2	Fully open panoramic sliding sunroof.	When removing seal (2, 3, 4, 6, 8, 9).
3	Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).	When removing seal (2, 3, 4, 6, 8, 9).
4	Remove seal (1, 7, 8, 9).	Seal (1, 7, 8, 9) is bonded.
		Replace seal (1, 7, 8, 9). Align seal (1, 7, 8, 9), glue on and press on with roller.
		Roller	Fig 1
5	Remove adhesive residues at panoramic sliding sunroof frame using a surface conditioning disk and clean bonding surface.
Topical note	Notes on removing adhesive residues and foils on paint and metal surfaces with surface conditioning disks		AH00.00-P-0013-01AK
		Cleaner	*BR00.45-Z-1025-04A
6	Remove seal (2, 3, 4, 5, 6).
7	Check seal (2, 3, 4, 5, 6) for damage.	If damage is detected, ↓ Replace seal (2, 3, 4, 5, 6).
8	Install in the reverse order.

Fig 1: Identifying Roller (168 589 05 63 00)

Courtesy of MERCEDES-BENZ USA