Remove/Install 12 Volt Socket - AR54.10-P-1000LW
Model 205, 213, 238, 253
MODIFICATION NOTES
| 05.03.2020 | Remove cover from center console. | Operation step 2. | |
| 05.03.2020 | Special tool changed. | Operation steps 5.1 and 5.2. |
Shown on model 205
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
| 2 | Remove cover from center console. | Model 213 with transmission 716 as of model year 2021 |
AR68.20-P-2350LWA |
| Model 213 with transmission 725 as of model year 2021 |
AR68.20-P-2350LW | ||
| Model 238 with transmission 716 as of model year 2021 |
AR68.20-P-2350LWP | ||
| Model 238 with transmission 725 as of model year 2021 |
AR68.20-P-2350LWO | ||
| 3 | Open flap (1). | ||
| 4 | Open flap (2) on vehicle interior socket (4). | ||
| 5.1 | Release and remove vehicle interior socket (4) using pull-off device (3). | Model 213, 238 as of model year 2021 |
Fig 2 |
| 5.2 | Release vehicle interior socket (4) using pull-off device (3) and pull out far enough to gain access to electrical connector (5). | Model 205, 253 Model 213, 238 up to model year 2021 Do not crush or kink or subject electric lines to tension. This will result in damage to the electric lines and can impair their function. |
Fig 2 |
| 6 | Release and disconnect electrical connector (5) and remove vehicle interior socket (4). | Model 205, 253 Model 213, 238 up to model year 2021 |
|
| 7 | Release catch hooks and remove clamping sleeve (6). | When replacing the vehicle interior socket (4). |
|
| 8 | Install in the reverse order. |