Electric Wiring Diagram For Panoramic Sliding Roof - PE77.20-P-2200-97FCA
Model 253 (except 253.99) as of model year 2020
with code 413 (Panoramic sliding sunroof/glass roof)
Control module A98
Model 253.99 as of model year 2019
with code 413 (Panoramic sliding sunroof/glass roof)
with code 9O1 (Fuel cell pre-installation)
Control module A98
| Code: | Designation: | Position: |
|---|---|---|
| A0 | Use of wiring diagrams | 48L |
| A98 | Panoramic sliding sunroof control module | 4A |
| A98 | Panoramic sliding sunroof control module | 12A |
| A98 | Panoramic sliding sunroof control module | 30A |
| A98 | Panoramic sliding sunroof control module | 39A |
| A98x1 | Panoramic sliding sunroof control module electrical connector | 5E |
| CAN B | Interior CAN | 13K |
| Code 9O1 | Fuel cell retrofitting | 1G |
| Code 9O1 | Fuel cell retrofitting | 6G |
| Code FV | LONG SEDAN | 18A |
| F1/3 | Passenger-side A-pillar fuse box | 4L |
| F1/3 | Passenger-side A-pillar fuse box | 9L |
| F1/3f309 | Fuse 309 | 3L |
| F1/3f317 | Fuse 317 | 8L |
| M12/5 | Panoramic sliding roof roller sun blind drive unit | 16L |
| M12/5b1 | Hall sensor 1, panoramic sliding roof roller sun blind | 14L |
| M12/5b2 | Hall sensor 2, panoramic sliding roof roller sun blind | 15L |
| M12/5m1 | Panoramic sliding roof roller sun blind motor | 17L |
| N10/6 | Front SAM control unit | 20L |
| N10/8 | Rear SAM control unit | 24L |
| S138/5 | Panoramic sliding sunroof roller sun blind button | 22A |
| W12 | Ground point (center console) | 21H |
| W15/7 | Right front footwell ground point | 11H |
| X204/1 | Panoramic roof roller sun blind electrical connector | 20E |
| X30/32 | Left interior CAN (CAN B) potential distributor electrical connector | 13L |
| X30/33 | Right interior CAN (CAN B) potential distributor electrical connector | 13L |
| Z51/6z1 | Circuit 58d vehicle interior connector sleeve | 20G |