Wiring Diagram For Battery Management Control Unit - PE54.10-P-2104-97FCB
Model 253 (except 253.99) as of model year 2020
with code ME05 (HYBRID DRIVE 80KW VARIANT (INCLUDING PLUGIN))
Control unit N82/2
| Code: | Designation: | Position: |
|---|---|---|
| A0 | Use of wiring diagrams | 72L |
| A100 | High-voltage battery module | 4A |
| A100 | High-voltage battery module | 12A |
| A100 | High-voltage battery module | 20A |
| A100 | High-voltage battery module | 28A |
| A100 | High-voltage battery module | 36A |
| A100 | High-voltage battery module | 48A |
| A100 | High-voltage battery module | 44A |
| A100f750 | Electrical fuse 750 | 40C |
| A100f751 | Electrical fuse 751 | 45C |
| A100g1 | High-voltage battery | 49A |
| A100n1 | High-voltage on-board electrical system insulation monitoring control unit | 46C |
| A100s1 | Contactor | 47C |
| A100s2 | Contactor | 47C |
| A79/1 | Electric machine | 36L |
| B69/7 | Battery management system temperature sensor | 29L |
| CAN L | Hybrid CAN | 20K |
| F34/6 | High-voltage distributor plate | 38J |
| F63 | Pyrofuse | 16L |
| K40/5 | Rear fuse and relay module | 8L |
| K40/5f412 | Fuse 412 | 7L |
| K40/8 | Engine fuse and relay module | 26L |
| K40/8f118 | Fuse 118 | 25L |
| N10/8 | Rear SAM control unit | 12L |
| N129/1 | Power electronics control unit | 41L |
| N82/2 | Battery management system control unit | 1A |
| N82/2 | Battery management system control unit | 54A |
| N82/2 | Battery management system control unit | 69A |
| N83/11 | Alternating current charger for high-voltage battery | 32L |
| N83/11 | Alternating current charger for high-voltage battery | 45L |
| W3/11 | Left rear wheel well ground point | 13H |
| W3/11 | Left rear wheel well ground point | 23H |
| W92/3 | Potential equalization ground point (high-voltage battery) | 46H |
| X18 | Cockpit wiring harness and frame floor assembly electrical connector | 16H |
| X22/4 | Transmission/frame floor assembly connecting point | 35H |
| X25/7 | Engine compartment/frame floor assembly electrical connector | 24E |
| X30/44 | Hybrid CAN (CAN L) potential distributor electrical connector | 20L |
| Y73/2 | Low-temperature circuit switchover valve 2 | 23L |
| Z141/2z1 | Circuit 87C connector sleeve | 24G |
| Z37/87z1 | Hybrid CAN (high) connector sleeve | 19G |
| Z37/88z1 | Hybrid CAN (low) connector sleeve | 20G |