Remove/Install Left/Right Rear Axle Speed Sensor - AR42.40-P-0820LW

Model 205 

Model 213 

Model 253 

Model 293 

Shown on model 205 

Fig 1: Left/Right Rear Axle Speed Sensor Components Location - Model 253 (Shown On Model 205)

Courtesy of MERCEDES-BENZ USA

Shown on model 213 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
Notice	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
Notice	Notes on self-locking nuts and Bolts		AH00.00-P-0001-01KOA
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1.1	Remove rear wheel.	Model 205, 253, 293	AR40.10-P-1102A
1.2	Raise vehicle.	Model 213	AR00.60-P-1006A
2	Release fender liner (1) in front area until electrical connector (3) is accessible and electric line (2) can be exposed.	Model 205, 253, 293	AR88.10-P-1400LW
3.1	Disconnect electrical connector (3) from rear axle left distributor electrical connector (X62/32) or rear axle right distributor electrical connector (X62/33).	Model 205 Model 253 Model 293
3.2	Release and disconnect electrical connector (6).	Model 213
4	Unscrew Bolt (4).	Bolt, RPM sensor to wheel carrier	*BA42.30-P-1001-02K
5	Remove holder (5) from left rear axle RPM sensor (L6/3) or right rear axle RPM sensor (L6/4) and hook up to one side.	Model 205, 213, 253 (except 253.388/389/988/989), 293
6.1	Expose electric line (2) of left rear axle RPM sensor (L6/3) or right rear axle RPM sensor (L6/4) and remove left rear axle RPM sensor (L6/3) or right rear axle RPM sensor (L6/4).	Model 205, 253, 293
6.2	Remove left rear axle RPM sensor (L6/3) or right rear axle RPM sensor (L6/4).	Model 213
7	Install in the reverse order.
8	Read out fault memory using diagnostic system and delete, if necessary.
		Model 205, 213, 253	AD00.00-P-2000-04B
		Model 293	AD00.00-P-2000-06FR