Remove/Install Pop-Up Bracket On Tilting/Sliding Roof - AR77.20-P-1700LW
Model 205.0/1
with code 414 (Electric sunroof, glass version)
Model 213.0/1/2
with code 414 (Electric sunroof, glass version)
Model 253
with code 414 (Electric sunroof, glass version)
Model 293
with code 414 (Electric sunroof, glass version)
Shown on right side of sliding roof frame (1)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove/install | |||
| 1 | Remove sliding sunroof frame (1). | Model 205.0/1 with code 414 (Electric sunroof, glass version) |
AR77.20-P-3000LWE |
| Model 213.0/1/2 with code 414 (Electric sunroof, glass version) Model 253 with code 414 (Electric sunroof, glass version) Model 293 with code 414 (Electric sunroof, glass version) |
AR77.20-P-3000LW | ||
| 2 | Remove screws (5) on the left and right side of the sliding roof frame (1). | ||
| 3 | Remove end piece (4) on left and right side of sliding roof frame (1). | Replace end pieces (4). Otherwise leakage can occur on sliding roof frame (1). |
|
| 4 | Bend end stops (7) on the left and right side downward. | Carefully bend end stops (7) downward. Otherwise, the end stops (7) may break. |
|
| 5 | Remove sliders (3) from sliding roof frame (1). | ||
| 6 | Remove sliders (9) from sliding roof frame (1) with assembly wedge (8). | Fig 1 | |
| 7 | Unclip cable (6) from tilting brackets (2) and remove. | ||
| 8 | Install in the reverse order. |