Remove/Install Front Axle RPM Sensor - AR42.30-P-0713MFA
Model 118, 177, 243, 247
Shown on left side of vehicle
| Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2 | Remove corresponding wheel and tire assembly. | AR40.10-P-1102MFA | |
| 3 | Release electrical connector (1) and disconnect. | ||
| 4 | Remove bolt (2). | *BA42.30-P-1001-01F | |
| 5 | Remove left front axle rpm sensor (L6/1) or right front axle rpm sensor (L6/2). | ||
| Check | |||
| 6 | Check left front axle rpm sensor (L6/1) or right front axle rpm sensor (L6/2) for damage. | If the left front axle rpm sensor (L6/1) or right front axle rpm sensor (L6/2) are damaged, ↓ replace left front axle rpm sensor (L6/1) or right front axle rpm sensor (L6/2). |
|
| 7 | Install in the reverse order. |
FRONT AXLE RPM SENSOR
| Number | Designation | Model 118 | Model 177 | |
|---|---|---|---|---|
| BA42.30-P-1001-01F | Bolt, rpm sensor to steering knuckle | Nm | 8 | 8 |
FRONT AXLE RPM SENSOR
| Number | Designation | Model 243 | Model 247 | |
|---|---|---|---|---|
| BA42.30-P-1001-01F | Bolt, rpm sensor to steering knuckle | Nm | 8 | 8 |