Remove/Install Side Paneling In Rear - AR68.30-P-4780MFX

Model 243.6, 247.6 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove/install
1.1	Remove seat backrest in rear.	Model 247.6 except code 567 (Vario rear seat)	AR91.12-P-1713MFA
1.2	Remove corresponding seats in the rear passenger compartment.	Model 243.6 Model 247.6 with code 567 (Vario rear seat)
		Model 243.6	AR91.12-P-4026EQB
		Model 247.6 with code 567 (Vario rear seat)	AR91.12-P-4026MFX
2	Remove top side trim in the trunk (2).		AR68.30-P-4805MFX
3	Unclip side trim (1).	Dismantling tool	Fig 1
4	Remove cover (4) and remove seat belt.	Dismantling tool	Fig 1
5	Remove side trim (1).	: Replace damaged retaining clips and retaining clamps. Ensure that the edge guard is seated correctly in the working area.
6	Install in the reverse order.

Fig 1: Identifying Dismantling Tool (000 589 95 63 00)

Courtesy of MERCEDES-BENZ USA