Remove/Install Front Stabilizer Bar Link Rod - AR32.35-P-3328LWX

Model 205 with code M005 (4MATIC) 

Model 213 with code M005 (4MATIC) 

Model 238 with code M005 (4MATIC) 

Model 253 

Shown on right side of vehicle on model 205 with code M005 (4MATIC) 

Fig 1: Front Stabilizer Bar Link Rod Components Location - Model 213 With Code M005 (Shown On Right Side On Model 205)

Courtesy of MERCEDES-BENZ USA

	Notes on handling, transport and storage of ceramic brake disks		AH42.10-P-9406-13A
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Note on calculation of tightening torque when using insertion or socket tools with various effective lengths		AH00.00-P-0015-01CW
	Notes on handling, transport and storage of composite brake disks		AH42.10-P-9406-12LF
	Notes on repair work on suspension components		AH00.00-P-0100-01A
	Remove/install
1	Remove front wheel		AR40.10-P-1102A
2	Unscrew nut (2)	Model 253Nut, torsion bar linkage to steering knuckle	*BA32.20-P-1003-02T
		Model 205 with code M005 (4MATIC) Model 213 with code M005 (4MATIC) Model 238 with code M005 (4MATIC) Nut, torsion bar linkage to steering knuckle	*BA32.20-P-1006-02R
3	Detach torsion bar linkage (1) from stabilizer bar (3)	Model 253Torsion bar linkage to torsion bar	*BA32.20-P-1002-02T
		Model 205 with code M005 (4MATIC) Model 213 with code M005 (4MATIC) Model 238 with code M005 (4MATIC) Torsion bar linkage to torsion bar	*BA32.20-P-1005-02R
4	Pull torsion bar linkage (1) out of steering knuckle (6)	The guide pin (4) must engage in the cutout (5) of the steering knuckle (6). Otherwise the steering knuckle (6) will be damaged.
	Check
5	Check ball heads and their boots of torsion bar linkage (1) for condition and damage	If a problem arises ↓ replace torsion bar linkage (1).
6	Install in the reverse order