Remove/Install Rear Axle Shaft Flange And Angular Ball Bearing - AR35.20-P-0130OLC
Model 213, 238
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A | ||
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| Remove | |||
| 1 | Remove wheel carrier (5) | Model 213, 238 Model 213 (except 213.064/088/089/164/264/288/289) |
AR35.20-P-0115LW |
| Model 238 | AR35.20-P-0115LWO | ||
| 2 | Remove screws (4) and take angular-contact ball bearing (2) with rear axle shaft flange (1) out of wheel carrier (5) | ||
| Clean | |||
| 3 | Clean water drain in wheel carrier (5) | Model 213 | AR35.20-P-0115-03CW |
| Model 238 | AR35.20-P-0115-03LWO | ||
| 4 | Clean contact surface on wheel carrier (5) | ||
| Install | |||
| 5 | Press new angular-contact ball bearing (2) onto new rear axle shaft flange (1) up to end stop using stamp (3) | When replacing the angular-contact ball bearing (2). The Otherwise damage will occur. |
|
| Fig 2 | |||
| 6 | Insert angular-contact ball bearing (2) with rear axle shaft flange (1) into wheel carrier (5) | ||
| 7 | Screw in screws (4) and tighten in diagonal pattern | *BA35.20-P-1001-06E | |
| 8 | Install wheel carrier (5) | Model 213, 238 Model 213 (except 213.064/088/089/164/264/288/289) |
AR35.20-P-0115LW |
| Model 238 | AR35.20-P-0115LWO |
HUB
| Number | Designation | Model 213 | Model 238 | |||
|---|---|---|---|---|---|---|
| BA35.20-P-1001-06E | Bolt, wheel bearing to wheel carrier | M10x41 | Nm | 70 | 70 | |
| M12x30 with cone | Stage 1 | Nm | 80 | - | ||
| Stage 2 | ∠° | 45 | - | |||
| M12x35 without cone | Stage 1 | Nm | 60 | - | ||
| Stage 2 | ∠° | 45 | - | |||