Install/Remove Emergency Buffer - AR32.00-P-1000LWE

Model 213.2 

except code 489 (AIRMATIC Dual Control/semi-active air suspension) 

Fig 1: Emergency Buffer Components Location - Model 213.2 Except Code 489

Courtesy of MERCEDES-BENZ USA

	Risk of death  caused by vehicle slipping or toppling off during lifting	Only lift vehicle at the lift support points specified by the vehicle manufacturer.	AS00.00-Z-0032-01A
	Notes on level control		AH32.22-P-1001-02LWT
	Install/remove
1	Raise vehicle at affected point at rear		AR00.60-P-1002LWG
2	Slide protective tube (3) downwards
3	Insert emergency buffer lower part (1) in upward direction up to end stop using guide pin	Set of emergency buffers	Fig 2
4	Insert emergency buffer upper part (2) in downward direction up to end stop using guide pin, and turn against emergency buffer lower part (1) up to end stop	Set of emergency buffers	Fig 2
5	Slide protective tube (3) together with emergency buffer lower part (1) and emergency buffer upper part (2) upward to suspension strut mount (4)
6	Slowly lower vehicle	The vehicle may be maneuvered only. Otherwise damage to the vehicle may occur.	AR00.60-P-1002LWG
7	Remove in the reverse order

Fig 2: Identifying Set Of Emergency Buffers (205 589 00 31 00)

Courtesy of MERCEDES-BENZ USA