(Attach/Detach Engine Support Fixture - AR01.10-P-2400-18OIB)

Engine 656 in model 213, 238, 257

	Risk of injury . Moving parts can pinch, crush or, in extreme cases even sever extremities.	No parts of the body or limbs should be within the operating area of mechanical components when moving components.	AS00.00-Z-0009-01A
	Notes on threaded connections fastened using a tightening angle-based tightening process		AH00.00-P-0020-01A

FROND END WITH FRONT REINFORCEMENT

Number	Designation				Model 213	Model 238
BA62.30-P-1001-02K	Screw/bolt, upper struts to suspension strut tower mounting bracket	Stage 1		Nm	35	35
		Stage 2		Nm	50	50
		Stage 3	Release	∠°	180	180
		Stage 4		Nm	50	50

FROND END WITH FRONT REINFORCEMENT

Number	Designation				Model 257
BA62.30-P-1001-02K	Screw/bolt, upper struts to suspension strut tower mounting bracket	Stage 1		Nm	35
		Stage 2		Nm	50
		Stage 3	Release	∠°	180
		Stage 4		Nm	50

Fig 1: Identifying Adapter (257 589 00 31 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Adaptation Of Engine Lifting Device (642 589 00 61 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Mount (240 589 00 61 10)

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Adapter Set (715 589 22 63 00)

Courtesy of MERCEDES-BENZ USA

Fig 5: Identifying Adaptation Plates (240 589 00 32 00)

Courtesy of MERCEDES-BENZ USA

Fig 6: Identifying Adapter Kit (240 589 01 31 00)

Courtesy of MERCEDES-BENZ USA

Fig 7: Identifying Engine Lifting Device (240 589 00 61 00)

Courtesy of MERCEDES-BENZ USA

Fig 8: Identifying Engine Hoist (205 589 00 61 00)

Courtesy of MERCEDES-BENZ USA

Remove covers (1).
Remove sealing (2).

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA
Remove plastic guides (4) and place to one side.
Remove screw/bolt/bolts (5) .
Install ring nuts (6) with thread adapter from adapter set and tighten.
Attach engine hoist (14) to engine hoist (8).
Install adapter (15) on engine hoist adaptation (16).
Install engine hoist adaptations (13, 16) on engine hoist (8).
Observe the manufacturer's assembly specifications and safety information.
Install mounts (9) on engine hoist adaptations (13, 16).
Install adapters (11) on left and right on adaptation plates (10).
Install adaption plates (10) on left and right on engine hoist (8).
Attach assembled engine hoist (8) to suspension strut towers and longitudinal members.
Observe the manufacturer's assembly specifications and safety information.

Aid of helper required.

Courtesy of MERCEDES-BENZ USA
Adjust engine hoist (8), align horizontally and tighten threaded connections.
Align adapters (11) on suspension strut towers and tighten wing nuts of adapters (11) on adaptation plates (10).
Secure tensioning straps (12) on engine hoist (8) and ring nuts from adapter set on left and right.
Install shackles on mounts (9) and engine lifting lugs (3).
Slightly tighten tensioning screws of mounts (9).
Do not subject engine mounts to tension.

Engine mount will otherwise be damaged
Remove in the reverse order.