Attach/Detach Engine Hoist - AR01.10-P-2400-17MRD

Model 206 with engine 254.9 

Model 206 with engine 654 

Model 213 with engine 264, 274, 642, 654 

Model 238 with engine 264, 274, 642, 654 

Model 257 with engine 264, 654 

Risk of injury  . Moving parts can pinch, crush or, in extreme cases even sever extremities.

No parts of the body or limbs should be within the operating area of mechanical components when moving components.

AS00.00-Z-0009-01A

Fig 1: Identifying Adaptation Plates (240 589 00 32 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Adapter Kit (240 589 01 31 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Engine Hoist (205 589 00 61 00)

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Engine Lifting Device (240 589 00 61 00)

Courtesy of MERCEDES-BENZ USA

Shown on model 213 with engine 274.9 except code ME05 (HYBRID DRIVE 80KW VARIANT (INCLUDING PLUGIN)) and ME06 (Hybrid drive 60 KW variant (including plugin)) 

Courtesy of MERCEDES-BENZ USA

Shown on model 213 with engine 274.9 except code ME05 (HYBRID DRIVE 80KW VARIANT (INCLUDING PLUGIN)) and ME06 (Hybrid drive 60 KW variant (including plugin)) 

Courtesy of MERCEDES-BENZ USA

1. Remove upper engine cover (9).
2. Remove right engine compartment cover (7).
3. Remove left engine compartment cover (8).
4. Remove seals (11).
5. Remove coolant expansion reservoir (10) and place to one side along with attached lines.
6. Model 213 with engine 274, 654

   with code ME05 (Hybrid drive 85 kW-94 kW variant (including plug-in))

   Model 213 with engine 274

   with code ME06 (Hybrid drive 60 kW variant (including plugin))

   Unclip purge valve from bracket of high-voltage battery cooling system expansion reservoir and place to one side.

7. Model 213 with engine 274, 654

   with code ME05 (Hybrid drive 85 kW-94 kW variant (including plug-in))

   Model 213 with engine 274

   with code ME06 (Hybrid drive 60 kW variant (including plugin))

   Remove high-voltage battery cooling system expansion reservoir and place to one side along with attached lines.

8. Model 213, 238, 257 with engine 264

   Remove expansion reservoir for low-temperature circuit and place with attached lines to one side .

9. Attach adapter plates (6) to engine support fixture (1).
10. Attach adapter (5) to adaptation plates (6).
11. Install adaptations (3) onto engine support fixture (1).
12. Preset engine support fixture (1).
13. Place engine support fixture (1) on suspension strut towers and longitudinal members.

    Aid of helper required.

14. Adjust engine support fixture (1), align it horizontally and tighten threaded connections.
15. Attach shackle between support (4) and the engine suspension lug.
16. Tighten turnbuckle of lifting device (2).

    When lifting engine, do not subject engine mounts to tension.

    The engine mount can get damaged otherwise.

17. Remove in the reverse order.