Remove/Install Left Or Right Rear Axle Speed Sensor - AR42.40-P-0820LW
Model 205
Model 213
Model 253
Model 293
MODIFICATION NOTES
| 20.04.2021 | Raise vehicle. | Operation step 1.2. |
Shown on model 205
Shown on Model 213
| Risk of injury
through cuts or scrapes on sharp-edged vehicle parts |
Always wear protective gloves when working on or in the area of sharp, unburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Information on preventing damage to electronic components through electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1.1 | Remove the rear wheel. | Model 205, 253, 293 | AR40.10-P-1102A |
| 1.2 | Raise vehicle. | Model 213 | AR00.60-P-1006A |
| 2 | Release fender liner (1) in front area until electrical connector (3) is accessible and electric line (2) can be exposed. | Model 205, 253, 293 | AR88.10-P-1400LW |
| 3.1 | Disconnect electrical connector (3) from rear axle left distributor electrical connector (X62/32) or rear axle right distributor electrical connector (X62/33). | Model 205 Model 253 Model 293 |
|
| 3.2 | Release and disconnect electrical connector (6). | Model 213 | |
| 4 | Unscrew bolt (4). | *BA42.30-P-1001-02K | |
| 5 | Remove holder (5) from left rear axle speed sensor (L6/3) or right rear axle speed sensor (L6/4) and hook up to one side. | Model 205, 213, 253 (except 253.388/389/988/989), 293 | |
| 6.1 | Uncover the electrical line (2) of the left rear axle speed sensor (L6 / 3) or the right rear axle speed sensor (L6 / 4) and remove the left rear axle speed sensor (L6 / 3) or right rear axle speed sensor (L6 / 4). | Model 205, 253, 293 | |
| 6.2 | Remove left rear axle speed sensor (L6 / 3) or right rear axle speed sensor (L6 / 4). | Model 213 | |
| 7 | Install in reverse order. | ||
| 8 | Read out the fault memory with the diagnosis system and delete if necessary. | ||
| Model 205, 213, 253 | AD00.00-P-2000-04B | ||
| Model 293 | AD00.00-P-2000-06FR |
REAR AXLE SPEED SENSOR
| Number | Designation | Model 205 | Model 213 | |
|---|---|---|---|---|
| BA42.30-P-1001-02K | Bolt speed sensor to the wheel carrier | Nm | 8 | 8 |
REAR AXLE SPEED SENSOR
| Number | Designation | Model 253 | Model 293 | |
|---|---|---|---|---|
| BA42.30-P-1001-02K | Bolt, the speed sensor to the wheel carrier | Nm | 8 | 8 |