Remove CROSSMEMBER - Ar64.20-P-1060-10FR

Model 257, 290 

Additional information can be found in the superordinate service document.

The safety information in the superordinate service document must be observed.

Courtesy of MERCEDES-BENZ USA

1. Coarsely cut the crossmember (2) and support angle (3) (areas A).
2. Remove section of crossmember (2) with support angle (3).

   The following operation steps 3 to 7 are shown on the left of the vehicle and must be performed advantageously on the right side.

3. Expose spot welds on the remaining section of the crossmember (2) and the support angle (3) and cut out (areas C, D).

   Cut out spot weld through two panel thicknesses (area D).

4. Remove remaining section of the crossmember (2) with the support angle (3).

   Courtesy of MERCEDES-BENZ USA

5. Sand down mating surfaces to bare metal in cross-hatched areas.

   Sand down spot weld flanges to bare metal on both sides.

6. Remove grinding dust and drill chips.
7. Coat insides of spot weld flanges with zinc dust paint.

   Courtesy of MERCEDES-BENZ USA