Check/Adjust Heads-Up Display - AR54.30-P-6401MFA

Model 118, 177, 243, 247

with code 463 (Head-up display)

Shown on model 177.087

Courtesy of MERCEDES-BENZ USA

Test image 1, target plot

Courtesy of MERCEDES-BENZ USA

Test image 7, target plot

Courtesy of MERCEDES-BENZ USA

	Preparatory tasks
1	Park the vehicle on a horizontal, level surface.
2	Close hood, doors and trunk lid or liftgate.
3	Switch on ignition.	No fault messages must be displayed on the multifunction display. Do not operate brake pedal.
4	Set driver's seat to correct ergonomic position.
5	Activate Head-up Display.
6	Call up workshop level in instrument cluster.
		Model 118, 177, 243, 247 with code 463 (Head-up display) except code 521 (Connect 20 Mid (NTG7)) except code 525 (Connect 20 High (NTG7))	AP00.20-P-0046C
		Model 118, 177, 243, 247 with code 463 (Head-up display) with code 521 (Connect 20 Mid (NTG7)) Model 118, 177, 243, 247 with code 463 (Head-up display) with code 525 (Connect 20 High (NTG7))	AP00.20-P-0046E
7	Swipe left on finger navigation pad (3) to select menu item "Head-up Display" in multifunction display (4) and confirm selection with finger navigation pad (3).
8	Swipe on finger navigation pad (3) to select "Test image" menu item and confirm selection.	"Off (original picture)" appears on the multifunction display (4).
9	Press on finger navigation pad (3) to call up list of available test images.
10	Swipe on finger navigation pad (3) to select "Test image 1" and confirm selection.	Test image 1 is shown on the windshield.
	Check
11	Check and assess test image 1.	The assessment must be performed by at least 2 persons. If test image 1 is shown correctly, ↓ continue with operation step 19.
12	Press on finger navigation pad (3) to call up list of available test images.
13	Swipe on finger navigation pad (3) to select "Test image 7" and confirm selection.
14	Check and assess test image 7.	The assessment must be performed by at least 2 persons. If test image 7 is shown correctly, ↓ continue with operation step 19.
	Adjust
15	Press "Back" button (2).
16	Swipe on finger navigation pad (3) to select "Parameters" menu item and confirm selection.
17	Swipe on finger navigation pad (3) to select menu item "Warp configuration" and confirm selection.	Parameters are reset.
18	Call up test image 1 and test image 7 again and assess them.	If test image 1 or test image 7 is not shown correctly, ↓ Under menu item "Parameters", select individual parameters and correct as required using "SET +" and "SET -" buttons.
	Final activities
19	Press finger navigation pad (3) and swipe on finger navigation pad (3) to select "Off (original picture)" and confirm selection.
20	Press "Back" button (2) repeatedly until menu selection is shown in multifunction display (4) and switch off ignition.	The workshop menu can only be completed by switching off the ignition.