Remove/Install Pedestrian Protection Sensor/Crash Sensor - AR91.60-P-0950MFA

Model 118, 177, 243, 247

with code U60 (Pedestrian protection - Active hood)

Fig 1: Pedestrian Protection Sensor/Crash Sensor Components Location - Model 118 With Code U60

G16053517

Courtesy of MERCEDES-BENZ USA

Topical note	Notes on pedestrian protection sensor		AH91.60-P-0001-01A
Topical note	General information on the impact absorber		AH88.20-P-1000-01A
Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Remove front bumper and place onto suitable base.	Model 118, 177, 247 with code U60 (Pedestrian protection - Active hood)	AR88.20-P-2000MFA
		Model 243 with code U60 (Pedestrian protection - Active hood)	AR88.20-P-2000EQA
2	Release and disconnect electrical connector (3) from front left bumper pedestrian protection sensor (B151/1) and from front right bumper pedestrian protection sensor (B151/3).
3	Remove impact absorber (2) from vehicle and place onto suitable base.
4	Remove front left bumper pedestrian protection sensor (B151/1) and front right bumper pedestrian protection sensor (B151/3) together with hose (1) from impact absorber (2).	: Route the hose (1) without any tension and kinking. Malfunctions can occur otherwise.
		: Check hose (1) is correctly seated in impact absorber (2). Make sure that the hose (1) is positioned as deeply as possible groove of the impact absorber (2).
		Do not detach the hose (1) from the front left bumper pedestrian protection sensor (B151/1) or front right bumper pedestrian protection sensor (B151/3).
	Check
5	Check front left bumper pedestrian protection sensor (B151/1) and front right bumper pedestrian protection sensor (B151/3) with hose (1) for any damage.	If there is a problem, ↓ replace front left bumper pedestrian protection sensor (B151/1) and front right bumper pedestrian protection sensor (B151/3) with hose (1).
6	Check impact absorber (2) for damage.	If there is a problem, ↓ Replace impact absorber (2).
7	Install in the reverse order.