Outer Rear Wheel Well Prepare For Installation - Ar63.10-P-0670-05MFC
Model 118.3
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1056-07A | 1K-zinc dust paint | A 000 986 28 00 |
The following operation steps are shown on the left side of the vehicle. This must be similarly performed for damage to the right side of the vehicle.
Additional information can be found in the superordinate service document.
Observe safety information in the superordinate service document.
- Grind mating surfaces on the outer rear wheel well (2) down to bare metal in cross-hatched areas.
Sand down spot weld flanges to bare metal on both sides.
- Remove grinding dust.
- Apply zinc dust paint to the insides of the spot weld flanges of the rear outer wheel well (2).
Do not coat bonding surfaces with zinc dust paint (area G).
Otherwise adhesion problems can occur.
Observe pretreatment of bonding surfaces.