Upper Front Longitudinal Member Preparation - Ar62.20-P-1286-02MFA

Model 118.3/6 

Model 177.0/1/9 

Model 247.0 

The next steps are shown on the left side of the vehicle. In case of damage on the right side of the vehicle, these steps must be performed analogously.

Further information can be found in the superordinate service document.

The safety information in the superordinate service document must be observed.

Courtesy of MERCEDES-BENZ USA

1. Grind mating surfaces on the upper front longitudinal member (1) down to bare metal in cross-hatched areas.

   

   Grind spot weld flanges down to bare metal on both sides.

2. Remove grinding dust.
3. Apply zinc dust paint to insides of spot weld flanges.

   Do not coat bonding surfaces with zinc dust paint coat (area A₁ ).

   Otherwise adhesion problems can occur.

   

   Observe pretreatment of bonding surfaces.