Seam Sealing Following Repair, Rear End Damage - Ar97.10-D-4000-02TS
Model 907
REPAIR MATERIALS
| Number |
Designation |
Order number |
| BR00.45-Z-1003-01A |
White sealing compound, 310 ml, DBL 6069.20 |
A 001 989 63 20 |
| BR00.45-Z-1041-01A |
Seam sealant, sprayable 310 ml |
A 002 989 84 20 |
- Seal body flanges of repaired area with sealant and spot welds and rivets of repaired area with seam sealant material.
Seal repaired body flanges and reset spot welds and rivets.
Leaks and corrosion can otherwise occur.
Use appropriate processing variant for seam seals.
Insert plastic plugs and rubber grommets with sealant.
Observe standard sealing. Seal only primed body parts.
Keep sealant out of threads on weld nuts and threaded pins by masking off or covering with cardboard sleeves. Also keep drain holes and contact surfaces of affected axle attachments and detachable parts free from sealant. Seal accessible spot weld flanges on both sides. Where only accessible from one side, only seal accessible area.
Processing variants for seam seals
Rear area
Underbody area, shown on model 907