Prepare Inner Part Of Rear-End Center Section For Installation - Ar64.20-D-1121-02TS

Model 907.6/7 

Additional information can be found in the superordinate service document.

The safety information in the superordinate service document must be observed.

1. Mark separating points on new part "rear-end center section inner part" (2) (areas A and B).

   Transfer separation points from vehicle.

2. Cut separating points on new part "rear-end center section inner part" (2) (areas A and B).

   Commercially available devices/tools 

   Body power jigsaw

3. Dispose of remaining sections of new part "rear-end center section inner part" (2).
4. Grind mating surfaces down to bare metal in cross-hatched areas at rear-end center section inner part (1).

   Sand down spot weld flanges to bare metal on both sides.

   Commercially available devices/tools 

   Rotary wire brush

5. Remove shavings.

   Commercially available devices/tools 

   Wet and dry vacuum cleaner

6. Zinc dust paint to insides of spot weld flanges.