Install And Weld In Outer Part Of Rear Center Section - Ar64.20-D-1000-10TS

	The high voltage used for electric welding presents a lethal hazard. Risk of explosion  from welding in areas close to highly inflammable materials. Risk of injury  from weld splatter and UV-light when welding. Risk of poisoning  from inhaling welding gases	Use insulating mats. Wear protective clothing, safety glasses and a protective mask. Remove highly inflammable materials from the hazard area. Use air extraction system.	AS00.00-Z-0007-01A
	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
	Measures for preventing damage to vehicles or components when performing electric welding work		AH00.00-N-0005-01A
	000 588 01 84 00 Welder		WS60.00-P-0021K
	000 588 02 84 00 Welder		WS60.00-P-0022K

Model 907.6/7 

The following operation steps are shown on model 907.733 with code D03 (Roof and rear-end doors, high version).

1. Install rear center section outer section (1), fit and fix in place.
2. Outer rear-end center section (1) (areas E and F).
3. Outer rear-end center section (1) (areas G and H).
4. Clean weld joints.
5. Remove shavings.