Separate Wheel Well Panel Front Section - Ar62.20-D-1280-01TS
| AR62.20-D-1280-01TS | Separate wheel well panel front section | ||
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A |
Model 907
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1056-07A | 1K-zinc dust paint | A 000 986 28 00 |
The following operation steps are shown on model 907.633 with code D03 (Roof and rear-end doors, high version) on the left side of vehicle and must be performed analogously on the right side of vehicle if damaged.
- Expose spot welds on wheel well paneling front section (1) (areas A, B and C).
- Cut off spot welds on wheel well paneling front section (1) (areas A, B and C).
- Remove damaged wheel well paneling front section (1).
- Grind down mating surfaces to bare metal in cross-hatched areas.
Sand down spot weld flanges to bare metal on both sides.
- Remove shavings and milling chips.
- Zinc dust paint to insides of spot weld flanges.