Install CROSSMEMBER Paneling Under Windshield - Ar62.25-D-0027-03TS

AR62.25-D-0027-03TS	Install crossmember paneling under windshield
	The high voltage used for electric welding presents a lethal hazard. Risk of explosion  from welding in areas close to highly inflammable materials. Risk of injury  from weld splatter and UV-light when welding. Risk of poisoning  from inhaling welding gases	Use insulating mats. Wear protective clothing, safety glasses and a protective mask. Remove highly inflammable materials from the hazard area. Use air extraction system.	AS00.00-Z-0007-01A
	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
	Measures for preventing damage to vehicles or components when performing electric welding work		AH00.00-N-0005-01A
	000 588 01 84 00 Welder		WS60.00-P-0021K
	000 588 02 84 00 Welder		WS60.00-P-0022K

Model 907 

Shown on model 907 

1. Install crossmember paneling under windshield (1), fit and fix in place.
2. Crossmember paneling under windshield (1) (areas C and D).
3. Crossmember paneling under windshield (1) (areas A and B).
4. Face-grind inert gas plug welds (areas A and B).
5. Clean weld joints.
6. Remove shavings.