LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2019 >> Sprinter 3500XD 2D Cab Chassis >> Repair and Diagnosis >> Brakes >> Traction Control >> Brakes - Description & Operation, Gen Info, Basic Knowledge, Safety, Testing, Maintenance, R&I >> Testing & Repair >> Remove/Install Left/Right Rear Axle Rpm Sensor - Ar42.40-D-9807TS

Remove/Install Left/Right Rear Axle Rpm Sensor - Ar42.40-D-9807TS

Model 907 

Shown on model 907 at left 

G13787503
  Risk of death  caused by vehicle slipping or toppling off of the lifting platform. Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. AS00.00-Z-0010-01A
REMOVINGINSTALLING Remove/install     
1 Raise vehicle   AR00.60-D-1000-04TS
  Special instructions for lifting and supporting vehicle   AH00.60-N-0100-01TS
2 Disconnect electrical connector (1) NOTESInstallation  :
Spray electrical connector (1) and RPM sensor (4) with sealing wax.
This prevents any ingress of moisture and corrosion formation in the electrical connector (1) and the axle tube.
NOTESInstallation  :
Seal openings in brake cover plate (5).
Otherwise, sealing wax may enter the brake disk and brakepads.
Sealing wax
*BR00.45-Z-1020-05A 
3 Remove screw/bolt (2) TORQUE SPECIFICATION Bolt, RPM sensor on rear axle *BA42.30-N-1001-02TS 
4 Remove RPM sensor (4) NOTESInstallation  :
Insert RPM sensor (4) until it lies in the mounting hole. Do not tilt RPM sensor (4). The mounting flange of the RPM sensor (4) must lie fully on and flush with the axle tube.
Otherwise, the RPM sensor (4) may be damaged when tightening the bolt (2).
 
5 Remove sealing ring (3) from RPM sensor (4) NOTESInstallation  :
Apply high-temperature antifriction bearing grease to new sealing ring (3).
This prevents any ingress of moisture and corrosion formation in the axle tube and the RPM sensor (4).
IMPORTANTInstallation  : Replace sealing ring (3).
MB high-temperature antifriction bearing grease, 150 g
*BR00.45-Z-1016-06A 
6 Install in the reverse order    
7 Read out the fault memory    
REFER TO SELF DIAGNOSTIC SYSTEMS Connect/disconnect diagnostic unit Depending on findings AD00.00-D-2000-06TS
   
Erase the fault memory.
 
TORQUE SPECIFICATION REAR AXLE RPM SENSOR

Number Designation Model 907
BA42.30-N-1001-02TS Bolt, RPM sensor on rear axle Nm 8
REPAIR MATERIALS

Number Designation Order number
BR00.45-Z-1016-06A MB high-temperature antifriction bearing grease, 150 g A 001 989 23 51 10
BR00.45-Z-1020-05A Sealing wax A 000 989 38 58