Remove paneling in trunk - AR68.30-P-4600W
MODEL 172.4
| Remove/install | |||
| 1 | Open trunk partition (1) | ||
| 2 | Unscrew nuts (5) and remove trunk partition (1) from trunk | ||
| 3 | Remove spare tire well (4) from trunk | ||
| 4 | Remove expansion clips (6) | Figure | |
| 5 | Lift center paneling (2) and pull out of cover (7) toward rear | ||
| 6 | Remove rear center section paneling (8) | ||
| 7 | Fix trunk partition closed limit switch (S69/10) in "closed" position with adhesive strips (9) | ||
| Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof | Keep body parts and limbs well clear of moving parts. | AS00.00-Z-0011-01A | |
| 8 | Positioning trunk lid to assembly position | AR88.50-P-5000-01V | |
| Fig 3 | |||
| 9 | Unclip right trunk lamp (E18/4) and lay toward inside through side luggage compartment lining (3) with electrical line connected | Only when removing right side luggage compartment lining (3). | |
| 10 | Remove expansion clip (10) and rubber bumper (11) from left and right mount (12). | ||
| 11 | Remove expansion clip (13) on left and right side luggage compartment lining (3) | Figure | |
| 12 | Open brush frame (14) on left or right side luggage compartment lining (3). For this purpose release lug (15) in direction of arrow and simultaneously press outer section (arrow D) of brush frame (14) downward. | ||
| 13 | Unclip clips (16) on left and right side luggage compartment lining (3) from mount (12) | ||
| 14 | Disconnect electrical connector (17) from trunk partition "closed" limit switch (S69/10) | Only when removing left side luggage compartment lining (3). | |
| 15 | Detach left and right side luggage compartment lining (3) all the away around, extract from tubular frame (18) and remove | ||
| 16 | Install in the reverse order |