Remove/Install Front Seat Frame Covers - AR91.10-P-1200LF
Model 217
Model 222
Shown on Model 222
Shown on Model 222 without CODE 682 (Fire extinguisher)
Shown on Model 222
| Remove/install | |||
| 1 | Move front seat (1) to foremost position and upwards | ||
| 2 | Remove belt end fitting (3) | MODEL 222 | AR91.40-P-1030-02LF |
| 3 | Unclip cover (5) | MODEL 222 |
|
| Fig 2 | |||
| 4 | Remove boot (4) | MODEL 222 |
|
| 5 | Unclip rear outer panel (2) and remove | Unclip rear outer panel (2), as shown, with Guide cable eye (7) through rear outer panel (2). Ensure that brackets (arrows B) are seated correctly in seat cushion frame. |
|
| Fig 1 | |||
| 6 | Unclip inner reinforcement (9) from rear outer panel (2) | MODEL 222 If the inner reinforcement (9) remains in the outer rear panel (2). |
|
| 7 | Attach inner reinforcement (9) on backrest frame | MODEL 222 Ensure that guide pin (10) is seated correctly in guide rail of inner reinforcement (9). |
|
| 8.1 | Open flap (11) and remove fire extinguisher | MODEL 217 with CODE 682 (Fire extinguisher) MODEL 222 with CODE 682 (Fire extinguisher) |
|
| 8.2 | Open flap (11) and clear out stowage compartment (13) | MODEL 217 without CODE 682 (Fire extinguisher) MODEL 222 without CODE 682 (Fire extinguisher) |
|
| 9 | Close flap (11) | ||
| 10 | Release front seat (1) and fold backward with electrical lines connected | AR91.10-P-1000LF | |
| 11 | Remove left and right screw/bolt (14) | ||
| 12 | Remove front outer panel (15) from bracket (16) | ||
| 13 | Swivel front outer panel (15), flap (11), front inner panel (12), stowage compartment (13) and frame upwards as a unit and remove from front seat (1) | without CODE 682 (Fire extinguisher) MODEL 222 without CODE 682 (Fire extinguisher) The stowage compartment (13) is only available for these vehicles. |
|
| 14 | Unclip front outer panel (15) from frame and remove | When replacing front outer panel (15). | |
| 15 | Unclip flap (11) and remove from frame | When replacing flap (11). | |
| 16 | Unclip front inner panel (12) and remove from frame | When replacing front inner panel (12). | |
| 17 | Release electrical connectors from front seat, disconnect and remove front seat (1) | AR91.10-P-1000LF | |
| 18 | Release electrical connectors (19) at rear inner panel (18) and remove | ||
| 19 | Unclip rear inner panel (18) and remove | Unclip inner rear panel (18) using Ensure that brackets (arrows E) are seated correctly in seat cushion frame. |
|
| Fig 1 | |||
| 20 | Unclip inner reinforcement (20) from rear inner panel (18) | MODEL 222 Only if inner reinforcement (20) remains in rear inner panel (18). |
|
| 21 | Attach inner reinforcement (20) on backrest frame | MODEL 222 Ensure that guide pin (21) is seated correctly in guide rail of inner reinforcement (20). |
|
| 22 | Install in the reverse order |