Remove/Install Front Seat Backrest Back Lining - AR91.10-P-1910LF

Model 217 

Model 222 

Courtesy of MERCEDES-BENZ USA

Shown on model 222 

	Remove
1	Release front seat and tilt with connected electrical lines.	Release and tilt front seat. Otherwise, the center console may be damaged.	AR91.10-P-1000LF
2	Remove screws (3) under seat backrest frame (7).
3	Unhook left and right holder (4) from respective guide (6).	Press seat-back lining (1) at level of holders (4) slightly inward and slide toward front. Pull seat-back lining (1) outward until holders (4) can be unhooked from guides (6).
4	Pull seat-back lining (1) downward and remove.
	Install
5	Position seat-back lining (1) and secure to seat backrest (2).	Handle the seat-back lining (1) with care. Otherwise, the contact areas of the seat-back lining (1) and trim parts of the seat may be damaged. Position the seat-back lining (1) at an angle, push against the front seat and insert the guides (arrows A) on the right and left in sequence by turning the seat-back lining (1) back and forth into the backrest frame (7). When doing so, spread seat-back lining (1) slightly outward at bottom and guide holders (4) into guides (6).
6	Tighten screws (3) below at seat backrest frame (7).
7	Install front seat.		AR91.10-P-1000LF