Remove/Install Outer Fan Motor Of Front Headlamp Unit - AR82.10-P-4743LFM
Model 217
Model 222
up to Model year 2018
With Code 640 (SAE dynamic LED headlamps, right-hand traffic)
Model 222
up to Model year 2018
With Code 641 (Dynamic LED headlamps, left-hand traffic)
Model 222
up to Model year 2018
With Code 642 (Dynamic LED headlamps, right-hand traffic)
Model 222
With Code 631 (Static LED headlamps, left-hand traffic)
Model 222
With Code 632 (Headlamps, LED, static, right-side traffic)
Fig 1: Outer Fan Motor Of Front Headlamp Unit Components Location - Model 222 Up To Model Year 2018 With Code 640, 641, 642, 631, 632 (Left Side Shown)
Shown on left front lamp unit (E1) up to Model year 2018
| Risk of injury caused by burns to skin and eyes, risk of poisoning caused by inhaling vapors when working with plastics | Wear protective gloves and safety glasses. Ensure that the work area is adequately ventilated. | AS00.00-Z-0001-02A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove | |||
| 1 | Remove left front lamp unit (E1) or right front lamp unit (E2) | Model 217 | AR82.10-P-4730LC |
| Model 222 | AR82.10-P-4730LF | ||
| 2.1 | Cut open housing of left front lamp unit (E1) or right front lamp unit (E2) inside web (1), along notch, using a hot knife | If no cap (5) is fitted. | |
| 000 588 03 84 00 Hot knife | WS82.00-P-0026B | ||
Do not damage the web (1). Otherwise the housing will not be leaktight. |
|||
Carefully cut open the housing. Otherwise, the component parts in the housing will be damaged. |
|||
| 2.2 | Remove screws (4) and cap (5) | If the cap (5) is fitted. | |
| 3 | Release and disconnect electrical connector (2) | ||
| 4 | Loosen mounting clamp (3) and remove left front lamp unit fan motor 1 (E1m4) or right front lamp unit fan motor 1 (E2m4), as applicable | ||
| Install | |||
| 5 | Insert left front lamp unit fan motor 1 (E1m4) or right front lamp unit fan motor 1 (E2m4) and secure with mounting clamp (3) | ||
| 6 | Put together electrical connection (2) until it is locked | ||
| 7 | Position cap (5) on web (1) and tighten with screws (4) | ||
| 8 | Install left front lamp unit (E1) or right front lamp unit (E2) respectively | Model 222 | AR82.10-P-4730LF |
| Model 217 | AR82.10-P-4730LC |