Remove/Install License Plate Lamps - AR82.10-P-5161LFM
Model 222
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notes on sensor system for trunk lid opening/closing | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove handle strip at trunk lid (2) | AR88.50-P-5062LF | |
| 2 | Detach trim inside trunk lid (2) until left license plate lamp (E19/1) or right license plate lamp (E19/2) is accessible | ||
| 3 | Release left license plate lamp (E19/1) or right license plate lamp (E19/2) and remove from trunk lid (2) until electrical connector (1) is accessible | ||
| 4 | Disconnect electrical connector (1) and remove left license plate lamp (E19/1) or right license plate lamp (E19/2) | ||
| 5 | Install in the reverse order |