Retrofit Front And Rear Illuminated Door Sill Molding With Mercedes-Benz Lettering - AZ82.20-P-0005-11LFM
Model 222.1
as of model year 2018
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1025-04A | Cleaner | A 005 989 19 71 |
Install illuminated door sill molding at front
Installation is described on the right side of the vehicle. Installation at the left-hand side of the vehicle takes place in the same way.
- Clean contact surface of right front door sill in the hatched area.
- Remove carrier foil (8) from the right front illuminated door sill molding (E17/48).
Pay attention to guides (9) during subsequent installation.
- Position right front illuminated door sill molding (E17/48) on longitudinal member and press on evenly.
- Connect black 2-pin connector of electrical line of right front illuminated door sill molding (E17/48) to black 2-pin connector of branch-off line of right front illuminated door sill molding (E17/48).
- Fasten right front illuminated door sill molding electrical connector (E17/48x1) by means of a retaining clip onto longitudinal member.
- Route electrical line of right front illuminated door sill molding (E17/48) via body flange on longitudinal member and fix in place with adhesive tape (10).
Install illuminated door sill molding at rear
- Clean contact surface of right rear door sill in the hatched area.
- Remove carrier foil (8) from the right rear illuminated door sill molding (E17/52).
- Connect black 2-pin connector (4) of right rear illuminated door sill molding to black 2-pin plug connector (3.4) of adapter wiring harness for right rear illuminated door sill molding (3.2).
- Route electrical line of right rear illuminated door sill molding through the body flange on the longitudinal member and fix in place with adhesive tape (11).