Remove/Install Rear Engine Mount - AR22.10-P-1160MNM

Engine 177 in model 217, 222 

Fig 1: Rear Engine Mount Components Location - Engine 177 In Model 222

Courtesy of MERCEDES-BENZ USA

	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
	Risk of injury.  Moving parts can pinch, crush or, in extreme cases even sever extremities.	No parts of the body or limbs should be within the operating area of mechanical components when moving components.	AS00.00-Z-0009-01A
	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
Notice	Notes on bolted connections with self tapping screws		AH00.00-P-0007-01SF
Notice	Notes on self-locking nuts and bolts		AH00.00-P-0001-01KOA
	Remove/install
1	Remove engine carrier		AR22.10-P-4360OIA
2	Remove screws (2) and remove engine mount (1) in downward direction	Bolt, rear engine mount to bracket/transmission	*BA22.10-P-1003-03K
3	Install in the reverse order

ENGINE MOUNT, ENGINE SUPPORT (ENGINE SIDE)

Number	Designation			Model 217 with engine 157, 176, 177, 278, 279	Model 222 except code Z07 (B7 armoring on special protection version)
BA22.10-P-1003-03K	Bolt, rear engine mount to bracket/transmission	M8	Nm	30	30
		M10	Nm	50	50

ENGINE MOUNT, ENGINE SUPPORT (ENGINE SIDE)

Number	Designation			Model 222 with code Z07 (B7 armoring on special protection version)
BA22.10-P-1003-03K	Bolt, rear engine mount to bracket/transmission	M8	Nm	30
		M10	Nm	50