Remove/Install Low-Temperature Circuit Coolant Expansion Reservoir Holder - AR09.41-P-0017MNM
Engine 177 in model 217, 222
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Remove/install | |||
| 1 | Remove upper engine cover. | ||
| 2 | Remove low-temperature circuit coolant-expansion reservoir upwards out of elastomer bearings and place to one side with connected lines. | ||
| 3 | Remove screw (3) of left gasoline particulate filter differential pressure sensor (B163/5). | Engine 177 in model 217, 222 with code 598 (Gasoline particulate filter (OPF) with sensor system) |
|
| *BA00.10-P-1002-04A | |||
| 4 | Remove screws (2). | *BA00.10-P-1002-04A | |
| 5 | Remove bracket (1). | ||
| 6 | Install in the reverse order. |
METRIC SCREWS/BOLTS AND NUTS AS PER MBN 10 105, 10 143
| Number | Designation | 8.8 | 10.9 | |
|---|---|---|---|---|
| BA00.10-P-1002-04A | M6X1 | Nm | 9 | 13 |