Remove/Install Propeller Shaft Center Support Bearing - AR41.40-P-0002-01LF
Model 217
Model 222
PROPELLER SHAFT
| Number | Designation | Model 222 | |
|---|---|---|---|
| BA41.10-P-1003-01J | Bolt, propeller shaft intermediate bearing/center reinforcement to frame floor assembly | Nm | 32 |
PROPELLER SHAFT INTERMEDIATE BEARING
| Number | Designation | Model 217 | |
|---|---|---|---|
| BA41.40-P-1002-01I | Screw/bolt, center reinforcement to frame floor assembly | Nm | 32 |
Detach
- Make a color marking to indicate the installation position of the reinforcement (1b) of the propeller shaft intermediate bearing (1) relative to the frame floor assembly.
- Unscrew the screws/bolts (1a) at the reinforcement (1b) of the propeller shaft intermediate bearing (1).
On vehicles with 3-piece propeller shaft, 4 screws/bolts must be removed at the reinforcement (1b) of the rear propeller shaft intermediate bearing (1).
Mount
- Loosely position screws/bolts (1a).
Screws/bolts (1a) may be tightened only after the flexible couplings are tightened at the transmission and rear axle differential.
Otherwise vibrations may be caused in the drive train and the propeller shaft center support bearing (1) may get damaged.
- Move propeller shaft intermediate bearing (1) to original installation position.
- Tighten screws/bolts (1a).
Shown on model 222 with 2-piece propeller shaft