LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2019 >> S450 Base >> Repair and Diagnosis >> Body & Frame >> Windows >> Doors - 222 Chassis (1 Of 2) >> Testing & Repair >> Remove/Install Rear Door Lining - AR72.12-P-1010LF

Remove/Install Rear Door Lining - AR72.12-P-1010LF

Model 222.0/1/9 

G15380310Courtesy of MERCEDES-BENZ USA

Shown on model 222.0 

G15380311Courtesy of MERCEDES-BENZ USA

Shown on model 222.0 

G15380312Courtesy of MERCEDES-BENZ USA

Shown on model 222.9 

Shown on model 222.9 

G15380313Courtesy of MERCEDES-BENZ USA
DANGER Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. No parts of the body or limbs should be within the operating area when the components are moving. AS00.00-Z-0011-01A
NOTES Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
REMOVINGINSTALLING Remove/install     
1 Lift catch hook on trim piece (3) through opening (arrow B) with suitable screwdriver, then slightly guide catch hook of trim piece (3) out of armrest and hold trim piece (3) so that the catch hook cannot stuck    
2 Unclip with trim piece (3) from front toward rear from remaining mounting points and remove INSTALLATION IMPORTANT : Ensure the trim piece (3) is seated correctly in armrest.  
    SPECIAL TOOL Clip remover Fig 1
3 Unlock catch hook (15) through opening (arrow C) in door lining (1) and remove switch pod (18) with left rear door power window switch (S21/3), right rear door power window switch (S21/4), left rear door switch group (S21/6) or right rear door switch group (S21/7) upward from door lining (1) IMPORTANT Do not disconnect electrical connector.  
4 Remove bolts (16)    
5 Remove bolt (16.1) Model 222.9  
6 Unclip left rear door exit/warning lamp (E17/5) or right rear door exit/warning lamp (E17/6) from door lining (1) IMPORTANT Do not disconnect electrical connector.  
    SPECIAL TOOL Clip remover Fig 1
7 Reach into opening (arrow A) and carefully unclip retaining clips (10) from door lining (1) NOTES
Unclip door lining (1) by hand.
The door lining (1) can be damaged when using the assembly wedge.
 
8 Unclip door lining (1) from retaining clip (19) in rear door (2) Model 222.0/1
with code 297 (Roller sun blinds in rear doors)
NOTES
Unclip door lining (1) by hand.
The door lining (1) can be damaged when using the assembly wedge.
 
9 Unhook inside door opener cable (5) on inside door handle (6)    
10 Unlock electrical connectors (7, 8) on left rear door control unit (N69/3) or right rear door control unit (N69/4) and remove    
11 Unlock electrical connectors (7.2, 7.3, 7.4) on left rear door control unit (N69/3) or right rear door control unit (N69/4) and remove Model 222.9  
12 Disconnect electrical connection (7.1) Model 222.9  
13 Unlock electrical connector (12) on left rear door midrange speaker (H4/80) or right rear door midrange speaker (H4/81) and remove    
14 Unlock electrical connector (13) on left rear door tweeter (H4/70) or right rear door tweeter (H4/71) and remove    
15 Unlock catch hook (21), push slide (20) downward and turn wire lock (22) in direction of arrow Model 222.9  
16 Pull door locking knob (4) with wire lock (22) out of door lining (1) and remove Model 222.9  
17 Remove door lining (1) IMPORTANT Guide left ear door exit and warning lamp (E17/5) or right rear door exit and warning lamp (E17/6) through door lining (1) with electrical line connected and allow to hang down.  
    INSTALLATION IMPORTANT : The new door lining (1) is delivered together with the speaker grille. If it is different than the previously installed speaker grille, transfer or replace.  
18 Install in the reverse order    
Fig 1: Identifying Clip Remover (452 589 01 63 00)
G15380314Courtesy of MERCEDES-BENZ USA