Remove/Install Complete Sideview Mirror - AR88.70-P-9000LFS

Model 222 

with code Z07 (B7 armoring on special protection version) 

Courtesy of MERCEDES-BENZ USA

Shown on left side of vehicle 

Shown on right side of vehicle 

Courtesy of MERCEDES-BENZ USA

Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Remove mirror triangle paneling (9) on left and right front door (7)	Mounting wedge	Fig 1
2	Remove door trim (2) from front door (7)		AR72.10-P-1000LF
3	Secure mirror triangle armor plate (11) against falling down
4	Unscrew bolts (12) from front door (7) and remove mirror triangle armor plate (11)	Bolt, armor plate to front door	*BA72.10-P-1009-01Y
5	Disconnect electrical connectors (3, 4) from front door control unit (5)
6	Unscrew bolts (6) and remove outside mirror (1) from front door (7)
7	Unclip electrical wiring harness (8) from bracket (10) and guide through passage (arrow)
8	Install in the reverse order
9.1	Calibrate 360° camera on left or right outside mirror (1) with diagnostic system	Model 222 with code 501 (360° camera) with code Z07 (B7 armoring on special protection version) If the left or right outside mirror (1) has been removed.
			AD00.00-P-2000-04B
9.2	Calibrate all the cameras for the 360° camera system using the diagnostic system	Model 222 with code 501 (360° camera) with code Z07 (B7 armoring on special protection version) If the left or right outside mirror (1) has been removed.
			AD00.00-P-2000-04B
	Check
10	Check outside mirror (1) for proper function

Fig 1: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA