Install Mounting Bracket On Lower Front Longitudinal Member - Ar62.20-P-1200-24LFS

Model 222 

with code Z07 (B7 armoring on special protection version) 

The following steps are shown on the left side of the vehicle and must be accomplished analogously on the right side in the event of damage.

When MIG welding ( ) prepare welds by grinding down to bare metal with stainless steel brush. Tack weld weld seams at start and end. Weld seam gap should not be greater than 1 mm, if required, preweld.

1. Install mounting console on front bottom longitudinal member (1) and fix in place.
2. Mounting console on bottom front longitudinal member (1) (areas A).

   Inert gas weld in intervals and allow to cool down in between. Reduces heat distortion.

   Courtesy of MERCEDES-BENZ USA

3. Weld ground bolt (2) to body.
4. Install ground line (3) between mounting console on bottom front longitudinal member (1) and body.

Courtesy of MERCEDES-BENZ USA