Remove/Install Partition Wall - AR68.74-P-0651GQS
MODEL 166
with CODE Z05 (B5 armoring on special protection version)
| Risk of injury from pinching or crushing hands and feet when working on windows. | Secure the windshields and windows against falling down; use only specified lifting tools; wear safety shoes. | AS67.00-Z-0003-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Notes on avoiding damage to windows installed in special high-security vehicles | AH67.00-P-0003-01FB | ||
| Remove/install | |||
| 1 | Fold up seat cushion | ||
| 2 | Fold backrest in rear toward front | ||
| 3 | Remove trim from C-pillar | MODEL 166 (except 166.8) with CODE Z05 (B5 armoring on special protection version) |
AR68.30-P-4490GQS |
| 4 | Unclip cover on bolts on vehicle interior partition wall paneling (3) | Carefully loosen cover. Otherwise damage will occur. |
|
| Fig 2 | |||
| 5 | Unscrew bolts on vehicle interior partition wall paneling (3) | ||
| 6 | Loosen vehicle interior partition window paneling (2) and remove | Carefully handle headliner, do not kink and lay down on clean base! Otherwise damage and soiling can occur. |
|
| 7 | Remove load compartment cover | ||
| 8 | Detach luggage compartment partition wall paneling (5) | Fig 2 | |
| 9 | Detach luggage compartment partition window paneling (4) | Fig 2 | |
| 10 | Unscrew bolts on partition wall (6) | ||
| 11 | Unscrew bolts on safety holder (7) and remove safety holder (8) | ||
| 12 | Remove rear headliner | AR68.30-P-7608GQ | |
| 13 | Remove side paneling in trunk | MODEL 166.0 with CODE Z05 (B5 armoring on special protection version) |
AR68.30-P-4800GQ |
| 14 | Remove trim from spare tire well | AR68.30-P-4620GQ | |
| 15 | Unscrew bolts on partition wall (6) and remove partition wall (1) | ||
| 16 | Install in the reverse sequence |