Install And Weld In Longitudinal Member Front Section - Ar62.20-P-1260-07GQ

Model 166, 292 

Courtesy of MERCEDES-BENZ USA

Shown on model 166 

1. Install longitudinal member front section, fit and fix in place.
2. Drill Ø 7 mm holes for in areas (C, F and FA).
3. Remove longitudinal member front section.
4. Deburr drill holes on both sides.
5. Install longitudinal member front section, fit and fix in place.
6. Longitudinal member front section rp (areas A, J and BA).
7. Longitudinal member front section SG (B, C, D, E, F, G, H, I, K, L and FA).
8. Clean welding areas.