Separate Main Floor, Inner Longitudinal Member And Seat Consoles - Ar63.40-P-1180-20GZ

Model 164, 166, 292 

Courtesy of MERCEDES-BENZ USA

Shown on model 164.8 

1. Expose spot welds and cut out (areas A, B, C and D).

   Expose area D from inside and cut out.

2. Remove tank holder (4).

   Courtesy of MERCEDES-BENZ USA

   Shown on model 164.8 

3. Expose spot welds and cut out (areas E, F, G, H and I).

   Cut out spot welds through two sheet metal thicknesses (areas F, G and I). Cut out spot weld marked with arrow through three layers.

4. Remove inner seat console (2).
5. Expose spot weld and cut out (area J).
6. Remove center tunnel reinforcement (3).
7. Model 166.8

   Expose MIG solder seams on left reinforcement (8) and grind off (areas XA and XB).

8. Model 166.8

   Expose spot welds on left reinforcement (8) and cut out (area YA).

9. Model 166.8

   Remove left reinforcement (8).

   Shown on model 166.8 

   Courtesy of MERCEDES-BENZ USA

   Shown on model 164.8 

   Courtesy of MERCEDES-BENZ USA

10. Scribe separating point and cut (area K).
11. Expose spot welds and cut out (areas L, M, N, O, P, Q, R, S, T, U, V, W, X, Z, QA and WA).

    Cut out spot welds from opposite side (area T). Cut spot welds through two panel thicknesses (areas N, Q, R and QA).

12. Remove outer seat console (1), connecting carrier on main floor (5) and remove main floor (6).
13. Expose spot welds and cut out (areas Y, AA and AB).
14. Remove damaged inner longitudinal member (7).

    Shown on model 164.8 

    Courtesy of MERCEDES-BENZ USA