Remove/Install Flywheel/Drive Plate - AR03.30-P-8001MLJ
ENGINE 157, 278 in MODEL 166
ENGINE 157, 278 in MODEL 292
| Remove/install | |||
| 1 | Remove transmission with torque converter | Model 166 with engine 278 with transmission 722.9 Model 292 with engine 278 with transmission 722.90 |
AR27.10-P-0500GQ |
| 2 | Install retaining lock for crankshaft/starter ring gear | AR03.30-P-5000GQ | |
| 3 | Remove screw/bolts (1a) from drive plate (1) | Do not use any impact wrench/driver or compressed air tool to screw the screw/bolts (1a) in and out. The thread in the crankshaft flange will be damaged otherwise. Replace screw/bolts (1a). |
AR03.30-P-8001-02MM |
| *BA03.30-P-1002-01M | |||
| 4 | Remove drive plate (1) from crankshaft flange | ||
| Check | |||
| 5 | Check threaded union (3) in the drive plate (1) | For damaged or loose threaded unions (3): ↓ Install new drive plate (1). |
|
| 6 | Install in the reverse order | ||
| 7 | Perform default initialization and then sensor rotor adaptation using the diagnostic system | Only perform when replacing the clutch plate (1). | |
|
AD00.00-P-2000-04A |
FLYWHEEL, DRIVE PLATE, VIBRATION DAMPER, STARTER RING GEAR
| Number | Designation | Engine 157 | Engine 278 | ||
|---|---|---|---|---|---|
| BA03.30-P-1002-01M | Bolt, starter ring gear/drive plate to crankshaft | Stage 1 | Nm | 20 | 20 |
| Stage 2 | Nm | 45 | 45 | ||
| Stage 3 | ∠° | 90 | 90 | ||