Separate Outer Rear Center Section - AR64.20-P-1000-01GQ

MODEL 166 except CODE Z04 (Light armoring) 

1. Expose spot welds on bottom rear center section (2) and cut out (areas A₁ , A₂ and A₃ ).

   Illustrated on model 166.0 

   Illustrated on model 166.0 

2. Expose spot welds on inner rear center section (1) and cut out (areas D₁ , D₂ , D₃ , D₄ , B₁ , B₂ , B₃ , B₄ , E₁ and E₂ ).
3. Drill ø 5.5 mm spot welds on inner rear center section (1) (areas C₁ and C₂ ).
4. Remove damaged inner rear center section (1).
5. Sand down mating surfaces to bare metal in cross-hatched areas.

   Sand down spot weld flanges to bare metal on both sides.

6. Remove shavings using wet/dry vacuum cleaner.
7. Coat insides of spot welding flanges with zinc dust paint.

   Illustrated on model 166.0