Install Rear Longitudinal Member Section - AR64.20-P-1260-03GQ

MODEL 166, 292 

The following steps are shown on the left side of the vehicle and must be accomplished analogously on the right side in the event of damage.

1. Install rear longitudinal member (3), fit and fix in place.
2. Rear longitudinal member (3) and rear reinforcements (3.1) (areas G1, G2 and G3).
3. Clean MIG welds on rear longitudinal member (3).
4. Grind inert gas welds down flat.
5. Remove shavings and drill chips.

   Shown on model 166.0 

6. Install rear longitudinal member cover (1) and locking lug (2), fit and fix in place.
7. Rear longitudinal member cover (1) and locking lug (2) (area I, J and K).
8. Rear longitudinal member cover (1) (area H).
9. Clean MIG welds on rear longitudinal member cover (1).
10. Grind inert gas welds down flat.
11. Remove shavings and drill chips.

Shown on model 166.0