Retrofit Front Mercedes-Benz Dashcam Mount - AZ54.71-P-0001-00LWG

Model 238, 253 

The following operation steps are shown on model 253 on the right side of the windshield. Optionally, the front Dashcam can also be installed on the left side of the windshield. The customer should be asked on which side of the windshield the Dashcam should be installed.

1. Clean surface of front Dashcam mount (8.15) on which the adhesive film (4) is glued.

   Remove yellow protective foil of adhesive film (4) at an angle of 180°.

   Before gluing, observe a flash-off time of 1 min after cleaning.

2. Glue adhesive film (4) onto front Dashcam mount (8.15) and press on firmly.
3. Fit front Dashcam (1) onto front Dashcam mount (8.15) and engage.

   Courtesy of MERCEDES-BENZ USA

4. Align front Dashcam (1) on windshield at right.

   For this, the front Dashcam (1) must make contact with the roof lining (arrows).

   Model 238.3

   Distance to A-pillar trim:

   Dimensions: 

   a = min. 175 mm.

   Model 238.4

   Distance to A-pillar trim:

   Dimensions: 

   a = 185 mm.

   Model 253

   Distance to A-pillar trim:

   Dimensions: 

   a = min. 140 mm.

   b = max. 375 mm.

   Courtesy of MERCEDES-BENZ USA

5. On the outside of the windshield, mark position of outer edge (arrows A) of front Dashcam mount (8.15) with tape.

   Helper required.

   Courtesy of MERCEDES-BENZ USA

6. Clean windshield on inside in crosshatched area.

   Courtesy of MERCEDES-BENZ USA

7. Glue covering foil (5) on windshield on inside as per the markings applied from outside.

   Remove protective foil of covering foil (5) at an angle of 180°.

   Before gluing, observe a flash-off time of 1 min after cleaning.

   There must be no gap visible between the screen print on the windshield and the covering foil (5).

8. Remove air bubbles under covering foil (5) to the side by hand.
9. Firmly press on covering foil (5).
10. Clean glued-on covering foil (5).
11. Remove markings on the outside of the windshield.

    Courtesy of MERCEDES-BENZ USA

12. Press Eject button (1.6) on front Dashcam (1).
13. Pull off front Dashcam (1) from front Dashcam mount in direction of arrow on Eject button (1.6).

    Courtesy of MERCEDES-BENZ USA

14. Pull red protective foil of adhesive film from front Dashcam mount (8.15).

    Pull off red protective foil at an angle of 180°.

15. Stick front Dashcam mount (8.15) in correct position on covering foil that has already been glued on and press on firmly.

    When pressing on, ensure that the pressure is applied directly on the adhesive point. The maximum adhesive strength is only reached after approx. 72 h at 20°C. During the first hour avoid the application of any mechanical load.

    Otherwise adhesion problems may occur.

Courtesy of MERCEDES-BENZ USA