Remove/Install Flexible Coupling Of Drive Shaft At Transmission End - AR41.10-P-0040-01LW
Model 205
Model 253
| Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A | ||
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| Drift for releasing the fitting sleeves in the flexible couplings | WF58.50-P-4110-01A |
PROPELLER SHAFT
| Number | Designation | Model 205 | Model 253 | |||
|---|---|---|---|---|---|---|
| BA41.10-P-1001-01L | Flex disk or joint flange at transmission/rear axle differential or propeller shaft | Self-locking nut | Nm | 68 | ||
| Direct threaded connection | Stage 1 | Nm | 60 | 60 | ||
| Stage 2 | ∠° | 90 | 90 | |||
Remove
- Make colored mark at position of propeller shaft (1) relative to flange of transmission or differential.
- Attach
counterholder to screws/bolts of flexible coupling (2) of rear axle differential.
For vehicles with direct bolted connection.
Helper required.
- Remove bolts (2a).
- Remove
Shown on flexible coupling on automatic transmission without direct bolted connection
- Release plug bushings of flexible coupling (2) using drift, as shown, from flange.
If necessary.
- Detach drive shaft (1) from flange of transmission or transfer case or rear axle differential.
Carefully detach drive shaft (1).
Otherwise the pilot bushing in the drive shaft (1) may be damaged.
Shown by way of an example on flexible coupling on rear axle differential
Install
- Restore original installation position of drive shaft (1) using colored marking.
For vehicles with direct bolted connection.
- Slide drive shaft (1) onto flange of transmission or transfer case or rear axle differential.
Otherwise the pilot bushing in the drive shaft (1) may be damaged.
- Attach
- Screw-in bolts (2a). Model 166
Model 292
Model 166
Model 292
Model 253
Model 207
Model 212
Model 218
Model 231
Model 207
Model 212
Model 218
Model 231
- Remove