Prepare Body Flange For Rear Glass Roof For Installation - AR77.21-P-0600-07NKX

Model 156 with code 413 (Automatic panoramic sliding sunroof) 

Model 205 with code 413 (Automatic panoramic sliding sunroof) 

Model 253 with code 413 (Automatic panoramic sliding sunroof) 

Shown on model 156 

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

Shown on model 156 

Shown on model 205 

Courtesy of MERCEDES-BENZ USA

1. Using a scraper, cut back adhesive bead (1) at body flange to a residual height of approx. 1 to 2 mm.
2. Completely cut back residues of spacers (2, 3) and adhesive bead (1) present in this area.
3. Remove cutting residues from body flange with wet/dry vacuum cleaner.
4. Repair paint damage on body flange.

   If required.

5. Apply primer in bonding area.

   In the case of missing residual adhesive material in bonding area.

1. 6.1 Model 156 with code 413 (Automatic panoramic sliding sunroof) Once primer has dried, glue on new spacers (2) so that flush with body flange edge.

   Dimension (A): 200 mm, measured from lower edge at transition of roof frame to body flange.

2. 6.2 Model 205, 253 with code 413 (Automatic panoramic sliding sunroof) Once primer has dried, glue on new spacers (2) at center on front and rear body flange.